Programming
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 173
5.1.13.6 Breast welt mode On/Off (745-35-10 A only) p. 173
5.1.16 Select pedal mode p. 233
5.1.15 Stacker/smoother/blow-off/roll-off p. 234
5.1.15.0 Select clamping time p. 234
5.1.15.3 Set lift transport clamp after corner cut p. 234
5.1.15.7 Set roll-off time (745-35-10 A only) p. 235
5.1.15.8 Set roll-off speed (745-35-10 A only) p. 235
5.1.15.6 Set time after roll-off until lift-up
(745-35-10 A only)
p. 235
5.1.15.5 Set roll-off time after corner cut
(745-35-10 A only)
p. 235
Tape trimming On/Off (745-35-10 A only) p. 196
5.2 Global parameters
5.2.1 Set positioning point seam begin./center/end p. 246
5.2.2 Adjust transport clamp p. 248
5.2.5 Adjust corner knife distance (745-35-10 S only) p. 257
5.2.7 Maximum hook thread counter p. 247
5.2.8 Hook thread monitor On/Off p. 247
5.2.10 Transport clamp quick adjustment p. 247
5.2.18 Set password protection p. 247
5.2.19 Set counting direction of piece counter p. 247
6.0 DAC internal For DA staff only
7.0 DAC update p. 269
8.0 USB data transfer
8.1 Data transfer to USB p. 285
8.2 Data transfer from USB p. 287
9.0 Init. parameters
Initialize machine configuration p. 289
Initialize global parameters p. 289
Menu item
Option/described
on page
To Next Page
Loading...
