Programming
172 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
5.1.5.1 Correction seam begin p. 207
5.1.5.2 Correction seam end p. 207
5.1.6 Marking lamps 1-16 (745-35-10 A only) p. 209
5.1.7 Sewing head parameters p. 210
5.1.7.1 Sewing speed p. 210
5.1.7.2 Set soft start parameters p. 211
5.1.7.3 Continuous or intermittent transport p. 210
5.1.7.5 Seam securement p. 212
5.1.8 Middle knife parameters p. 213
5.1.8.1 Middle knife On/Off p. 213
5.1.8.2 Speed middle knife p. 213
5.1.8.3 Set middle knife correction seam begin. p. 213
5.1.8.4 Set middle knife correction seam end p. 213
5.1.9 Corner knife (straight pocket) p. 215
5.1.9.1 Corner knife (slanted pocket) (745-35-10 A only) p. 217
5.1.10 Automatic tape feeder On/Off (745-35-10 A only) p. 220
5.1.10.2 Set length of tape at seam begin (745-35-10 A only) p. 220
5.1.10.3 Set length of tape at seam end (745-35-10 A only) p. 220
5.1.11 Transport clamp p. 221
5.1.11.1 Set return speed p. 221
5.1.11.2 Set insertion speed p. 221
5.1.11.4 Return of transport clamp p. 222
5.1.11.5 Waiting position of transport clamp p. 223
5.1.12 Process of transport clamp p. 226
5.1.12.1 Select transport clamp quick adjustment
(745-35-10 A only)
p. 225
5.1.12.2 Select process of transport clamp p. 226
5.1.13 Program loading process p. 227
5.1.13.1 Select flap clamps p. 227
5.1.13.2 Vacuum On/Off p. 227
5.1.13.3 Downholder On/Off p. 227
5.1.13.4 Select downholder mode (745-35-10 A only) p. 228
5.1.13.5 Set blowing mode (745-35-10 A only) p. 230
Menu item
Option/described
on page
To Next Page
Loading...
