ELTEX ESR Series - Page 242

ESR-Series. User manual
242
•
•
Step Description Command Keys
34 Specify OSFP authentication algorithm. esr(config-if-gi)# ip ospf
authentication algorithm
<ALGORITHM>
<ALGORITHM> –
authentication algorithm:
cleartext – password,
transmitted in clear text;
md5 – password is
hashed by md5
algorithm.
35 Set the password for OSPF neighbor
authentication when transmitting an
unencrypted password.
esr(config-if-gi)# ip ospf
authentication key ascii-text
{ <CLEAR-TEXT> | encrypted
<ENCRYPTED-TEXT> }
<CLEAR-TEXT> – password,
set by the string of 8 to 16
characters;
<ENCRYPTED-TEXT> –
encrypted password of 8 to 16
bytes (from 16 to 32
characters) in hexadecimal
format (0xYYYY ...) or
(YYYY ...).
36 Specify the list of passwords for
neighbor authentication via md5
hashing algorithm.
esr(config-if-gi)# ip ospf
authentication key-chain
<KEYCHAIN>
<KEYCHAIN> – key list
identifier, set by the string of up
to 16 characters.
37 Set the time interval in seconds after
which the router selects DR in the
network.
esr(config-if-gi)# ip ospf wait-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 40 seconds.
esr(config-if-gi)# ipv6 ospf wait-
interval <TIME>
38 Set the time interval in seconds after
which the router re-sends a packet that
has not received a delivery confirmation
(for example, a DatabaseDescription
packet or LinkStateRequest packets).
esr(config-if-gi)# ip ospf
restransmit-interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 5 seconds.
esr(config-if-gi)# ipv6 ospf
restransmit-interval <TIME>
39 Set the time interval in seconds after
which the router sends the next hello
packet.
esr(config-if-gi)# ip ospf hello-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 10 seconds.
esr(config-if-gi)# ipv6 ospf hello-
interval <TIME>
40 Set the time interval in seconds after
which the neighbor is considered to be
idle. This interval should be a multiple
of the ‘hello interval’ value.
esr(config-if-gi)# ip dead-interval
<TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 40 seconds.
esr(config-if-gi)# ipv6 dead-
interval <TIME>