•
•
•
•
•
Step Description Command Keys
41 Set the time interval during which
NBMA interface waits before sending a
HELLO packet to a neighbor, even if the
neighbor is idle.
esr(config-if-gi)# ip poll-interval
<TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 120 seconds.
esr(config-if-gi)# ipv6 poll-interval
<TIME>
42 Set static IP address of a neighbor to
establish a relation in NMBA and P2MP
(Point-to-MultiPoint) networks.
esr(config-if-gi)# ip ospf neighbor
<IP> [ eligible ]
<IP> – neighbor’s IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values
of [0..255].
eligible – optional parameter,
allows the device to take part in
DR selection process in NMBA
networks. The interface priority
should be greater than zero.
esr(config-if-gi)# ip ospf neighbor
<IP> [ eligible ]
<IPV6-ADDR> – neighbor’s IPv6
address, defined as X:X:X:X::X
where each part takes values in
hexadecimal format [0..FFFF];
eligible – optional parameter,
allows the device to take part in
DR selection process in NMBA
networks. The interface priority
should be greater than zero.
43 Define the network type for OSPF
neighborhood establishment.
esr(config-if-gi)# ip ospf network
<TYPE>
<TYPE> – network type:
broadcast – broadcast
connection type;
non-broadcast – NBMA
connection type;
point-to-multipoint –
point-to-multipoint
connection type;
point-to-multipoint non-
broadcast – point-to-
multipoint NBMA
connection type;
point-to-point – point-to-
point connection type.
Default value: broadcast.
esr(config-if-gi)# ipv6 ospf
network <TYPE>
44 Set the router priority that is used for DR
and BDR selection.
esr(config-if-gi)# ip ospf priority
<VALUE>
<VALUE> – interface priority,
takes values of [1..65535].
Default value: 120.
To Next Page
Loading...
Need help?
General
