ELTEX ESR Series - Page 257

ESR-Series. User manual
257
Step Description Command Keys
22 Set the time of minimum and maximum
delay during which it is prohibited to
establish a connection in order to
prevent frequent disconnections
(optionally).
esr(config-bgp-af)# timers error-
wait <TIME1> <TIME2>
<TIME1> – minimum delay
time in seconds, takes values
of [1..65535].
<TIME2> – maximum delay
time in seconds, takes values
of [1..65535].
Default value: 60 and 300
seconds
23 Set the number of BGP neighbor stand
alone system.
esr(config-bgp-neighbor)# remote-
as <AS>
<AS> – stand alone system
number, takes values of
[1..4294967295].
24 Allow connections to neighbors that are
located not in directly connected
subnets (optional)
esr(config-bgp-neighbor)# ebgp-
multihop <NUM>
<NUM> – maximum amount of
hops when installing EBGP
(used for TTL).
25 Specify BGP neighbor as a Route-
Reflector client. (optional)
esr(config-bgp-neighbor)# route-
reflector-client
26 Set IP/IPv6 router address that will be
used as source IP/IPv6 address in
transmitted BGP route information
updates. (optionally)
esr(config-bgp-neighbor)# update-
source { <ADDR> | <IPV6-ADDR> }
<ADDR> – source IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values of
[0..255];
<IPV6-ADDR> – source IPv6
address, defined as X:X:X:X::X
where each part takes values in
hexadecimal format [0..FFFF].
27 Enable the mode in which the reception
of routes in the BGP attribute, AS Path
of which includes the numbers of
process stand alone system, is allowed.
(optionally)
esr(config-bgp-neighbor)# allow-
local-as <NUMBER>
<NUMBER> – threshold
amount of instances of
autonomous system number in
the AS Path attribute at which
the route will be accepted, the
range of acceptable values
[1..10].
28 Enable the BFD protocol on the
configured BGP neighbor. (optional,
used in conjunction with the update-
source parameter)
esr(config-bgp-neighbor)# bfd-
enable
29 Specify neighbor authentication
algorithm (optionally).
esr(config-bgp-neighbor)#
authentication algorithm
<ALGORITHM>
<ALGORITHM> – encryption
algorithm:
md5 – password is encrypted
by md5 algorithm.