ELTEX ESR Series - Page 269

ESR-Series. User manual
269
S
t
e
p
Description Command Keys
esr(config-route-map-
rule)# match ipv6 next-
hop object-group <OBJ-
GROUP-NETWORK-
NAME>
9 Set the profile that includes IP
addresses of the router having
advertised the route for which the
rule should work (optionally).
esr(config-route-map-
rule)# match ip route-
source object-group
<OBJ-GROUP-NETWORK-
NAME>
<OBJ-GROUP-NETWORK-NAME> – name of
the IP addresses profile that includes
destination subnets prefixes, set by the string
of up to 31 characters.
esr(config-route-map-
rule)# match ipv6 route-
source object-group
<OBJ-GROUP-NETWORK-
NAME>
1
0
Specify ACL group for which the rule
should work.
esr(config-route-map-
rule)# match access-
group <NAME>
<NAME> – access control list name, set by the
string of up to 31 characters.
1
1
Set BGP MED attribute value in the
route for which the rule should work
(optionally).
esr(config-route-map-
rule)# match metric bgp
<METRIC>
<METRIC> – BGP MED attribute value, takes
values in the range of [0..4294967295].
1
2
Set OSPF Metric attribute value in the
route for which the rule should work.
esr(config-route-map-
rule)# match metric ospf
<TYPE> <METRIC>
<TYPE> – OSPF Metric attribute type, takes
values type-1 and type-2;
<METRIC> – OSPF Metric attribute value, takes
values in the range of [0..65535].
1
3
Set RIP Metric attribute value in the
route for which the rule should work.
esr(config-route-map-
rule)# match metric rip
<METRIC>
<METRIC> – RIP Metric attribute value, takes
values in the range of [0..16].
1
4
Set OSPF Tag attribute value in the
route for which the rule should work.
esr(config-route-map-
rule)# match tag ospf
<TAG>
<TAG> – OSPF Tag attribute value, takes
values in the range of [0..4294967295].
1
5
Set RIP Tag attribute value in the
route for which the rule should work.
esr(config-route-map-
rule)# match tag rip
<TAG>
<RIP> – RIP Tag attribute value, takes values in
the range of [0..65535].