ELTEX ESR Series - Page 271

ESR-Series. User manual
271
•
•
•
•
•
•
S
t
e
p
Description Command Keys
2
0
Specify Next-Hop value that will be
set in the route received by BGP
(optionally).
esr(config-route-map-
rule)# action set ip next-
hop {NEXTHOP> |
blackhole | unreachable |
prohibit}
<NEXTHOP> – gateway IP address, defined as
AAA.BBB.CCC.DDD where each part takes
values of [0..255];
blackhole – packets to this subnet will
be removed without sending
notifications to a sender;
unreachable – packets to this subnet
will be removed, a sender will receive in
response ICMP Destination
unreachable (Host unreachable, code
1);
prohibit – when specifying the
command, the packets to this subnet
will be removed by the device, a sender
will receive in response ICMP
Destination unreachable
(Communication administratively
prohibited, code 13);
esr(config-route-map-
rule)# action set ipv6
next-hop <IPV6-
NEXTHOP>
<IPV6-ADDR> – gateway IPv6 address, defined
as X:X:X:X::X where each part takes values in
hexadecimal format [0..FFFF].
2
1
Specify BGP Local Preference
attribute value that will be set in the
route (optionally).
esr(config-route-map-
rule)# action set local-
preference
<PREFERENCE>
<PREFERENCE> – BGP Local Preference
attribute value, takes values in the range of
[0..255].
2
2
Specify BGP Origin attribute value
that will be set in the route
(optionally).
esr(config-route-map-
rule)# action set origin
<ORIGIN>
<ORIGIN> – BGP Origin attribute value:
egp – route is learnt by EGP;
igp – route is received inside the initial
AS;
incomplete – route is learnt in another
way.
2
3
Specify BGP MED value that will be
set in the route
(optionally).
esr(config-route-map-
rule)# action set metric
bgp <METRIC>
<METRIC> – BGP MED attribute value, takes
values in the range of [0..4294967295].