ELTEX ESR Series User Manual

ESR-Series. User manual
338
Check the service state:
PE2# sh mpls l2vpn vpls l2vpn
VPLS: l2vpn
bridge 1:
MTU: 1500
Status: Up
ACs:
gigabitethernet 1/0/4:
MTU: 1500
Status: Up
PWs:
PW ID 2, Neighbor 10.10.0.1:
MTU: 1500
Last change: 00:21:33
Status: Up
The calculated service marks can be viewed as follows:
1)
PE2# sh mpls l2vpn bindings
Neighbor: 10.10.0.1, PW ID: 2, VE ID: 1
Local label: 45
Encasulation Type: VPLS
Control flags: 0x00
MTU: 1500
Remote label: 87
Encasulation Type: VPLS
Control flags: 0x00
MTU: 1500
2)
PE2# sh mpls forwarding-table
Local    Outgoing  Prefix       Outgoing Next Hop
label label or tunnel ID Interface
----------------    ----------------- ----------------
----------------------------------

4587 PW ID 2          --10.10.0.1


ELTEX ESR Series Specifications

General

Model	ESR Series
Category	Network Router
Manufacturer	ELTEX
Management	Web interface, CLI, SNMP
Operating Temperature	0°C to 40°C
Dimensions	Varies by model
Weight	Varies by model
Routing Protocols	OSPF, BGP
WAN Interfaces	Ethernet, SFP
LAN Interfaces	Ethernet, SFP
VPN Support	IPsec, L2TP, PPTP
Firewall	Stateful packet inspection, ACLs
Power over Ethernet (PoE)	Available on some models
QoS	Traffic prioritization