Epson AcuLaser C1100 - Page 342

EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY TRANSFER 342
 COVER ASSY-RR 2ND
1. Remove COVER ASSY LH. (p.295)
2. Unclamp the clamp fastening the harness of COVER ASSY-RR 2ND, and remove
the harness.
3. Disconnect connector (P/J621) connected to the main unit, and insert the
connector inside through the hole on the main unit.
4. Remove the 2 screws (silver, with flange, 8 mm) fastening COVER ASSY-RR
2ND to the main unit.
5. Remove COVER ASSY-RR 2ND from the main unit.
Figure 4-58. Removal of COVER ASSY-RR 2ND
C A U T I O N
When performing the following work, leave the intermediate
connector on the harness side.
Leg_Sec03_143EB
CAUTION
8)
7)
7)
6)-1
5)
6)-2