Epson AcuLaser C1100 - Page 59

EPSON AcuLaser C1100 Revision B
PRODUCT DESCRIPTION Printer Status 59
NonGenuineToner uuuu
 Explanation
A non-genuine Toner Cartridge is installed.
 Remedy
 Open cover A, install the right Toner Cartridge.
The printer recovers from the error when the cover is closed.
 Press the Start/Stop button.
The message will change to “Non Genuine Toner” and enables the user to
print.
TonerCart Error uuuu
 Explanation
The Toner Cartridge CSIC cannot be read/written correctly.
 Remedy
Open cover A, reinstall the Toner Cartridge, or replace it with a correct Toner
Cartridge.
The printer recovers from the error when the cover is closed.
Replace Toner uuuu
 Explanation
The Toner Cartridge comes to the end of its life.
 Remedy
Open cover A and install the Toner Cartridge in the replacement position.
The printer recovers from the error when the cover is closed.
When several cartridges come to the end, next cartridge is set to replacement
position after cover A is closed.
NOTE: When several cartridges come to the end all at once, the order of the
replacement is K, Y, M, C. When finished to replace the first one and
close the cover A, “Install uuuu TnrCart” is displayed after next
cartridge is set at the replacement position.
(The user opens the cover again by seeing the message.)
w w w w Open (w w w w=A, B, C, D, DM, E, F, G)
 Explanation
The indicated cover is open.
 Remedy
The printer recovers from the error by closing the cover.
NOTE: When multiple covers are open, they are displayed as much as possible in
the following order.
A, B, C, D, DM, G
Manual Duplex
 Explanation
Printing is stopped, because the print of one side is finished in manual duplex
printing.
When manual duplex printing is specified, the errors below are not occurred.
 Paper Set
 Check Paper Size
 Remedy
 Set the one-side printed sheet into MP tray and press the Start/Stop button to
print on the other side.
 Cancel the job if there is no need to print on the other side.
NOTE: With manual duplex printing, back pages (even-numbered pages) are
printed first in descending order and piled up face down.
To print the front pages (odd numbered pages), put the face-down piled-
up sheets directly into the MP tray as the front pages are printed in
ascending order.
Second pass of Manual Duplex is engine setting for reverse side.
This setting should be conducted before display of Manual Duplex.