Service Manual_AVA1_ENG-20220922_I 86
DM1&DM2: Ink
Action Check > DM1&DM2 : Ink >
Low speed operation check of the Ribbon Wind Up Motor
(DM1)/Ribbon Supply Motor (DM2)
(feed direction)
To operate the Ribbon Wind Up Motor (DM1) and Ribbon Supply
Motor
(DM2) for the specified period of time (1 to 20 seconds) to the
- od
Select the item, and then press SET key.
Because the printer becomes operation failure, do not press the
SET key to stop during oper
ation. If it has been stopped, turn
The motor control for the primary transfer is performed.
Low speed operation check of the Ribbon Wind Up Motor
(DM1)/Ribbon Supply Motor (DM2)
(reverse direction)
To operate the Ribbon Wind Up Motor (DM1) and Ribbon Supply
Motor
(DM2) for the specified period of time (1 to 20 seconds) to the
od
Select the item, and then press SET key.
Because the printer becomes operation failure, do not press the
SET key to stop during operation.
If it has been stopped, turn
The motor control for the primary transfer is performed.
High speed operation check of the Ribbon Wind Up Motor
(DM1)/Ribbon
Supply Motor (DM2) (feed direction)
To operate the Ribbon Wind Up Motor (DM1) and Ribbon Supply
Motor
(DM2) for the specified period of time (1 to 20 seconds) to the
Select the item, and then press SET key.
Because the printer becomes operation failure, do not press the
SET key to stop during oper
ation. If it has been stopped, turn
The motor control for the normal feed is performed.
High speed operation check of the Ribbon Wind Up Motor
(DM1)/Ribbon Supply Motor (DM2)
(reverse direction)
To operate the Ribbon Wind Up Motor (DM1) and Ribbon Supply
Motor (DM2)
for the specified period of time (1 to 20 seconds) to the
Select the item, and then press SET key.
Because the printer becomes operation failure, do not press the
SET key to stop during operation.
If it has been stopped, turn
The motor control for the normal feed is performed.
To Next Page
Loading...
