Evolis Avansia - DM3&DM4: Film

Service Manual_AVA1_ENG-20220922_I 87
DM3&DM4: Film
Action Check > DM3&DM4: Film >
Low:
Forward
Overview
Low speed operation check of the Film Wind Up Motor
(DM3)/Ribbon Film Supply Motor
- Low: Forward Overview Low
speed operation check of the Film Wind Up Motor
(DM3)/ Ribbon
Film Supply Motor (DM4) (feed direction)
Detail
To operate the Film Wind Up Motor (DM3) and Ribbon Film
Supply Motor (DM4) for the
specified period of time (1 to 20
seconds) to the feed direction.
Use Case
Checking the operation
Adj/Set/Operate
Method
Select the item, and then press SET key.
Caution
Because the printer becomes operation failure, do not press the
SET key to stop during
operation. If it has been stopped, turn
OFF/ON the power switch.
Supplement/Memo
The motor control for the primary transfer is performed.
Low:
Reverse
Overview
Low speed operation check of the Film Wind Up Motor
(DM3)/Ribbon Film Supply Motor
(DM4) (reverse direction)
Detail
To operate the Film Wind Up Motor (DM3) and Ribbon Film
Supply Motor (DM4) for the
specified period of time (1 to 20
seconds) to the reverse direction.
Use Case
Checking the operation
Adj/Set/Operate
Method
Select the item, and then press SET key.
Caution
Because the printer becomes operation failure, do not press the
SET key to stop during
operation. If it has been stopped, turn
OFF/ON the power switch.
Supplement/Memo
The motor control for the primary transfer is performed.
High
:
Forward
Overview
High speed operation check of the Film Wind Up Motor
(DM3)/Ribbon Film Supply Motor
(DM4) (feed direction)
Detail
To operate the Film Wind Up Motor (DM3) and Ribbon Film
Supply Motor (DM4) for the
specified period of time (1 to 20
seconds) to the feed direction.
Use Case
Checking the operation
Adj/Set/Operate
Method
Select the item, and then press SET key.
Caution
Because the printer becomes operation failure, do not press the
SET key to stop during
operation. If it has been stopped, turn
OFF/ON the power switch.
Supplement/Memo
The motor control for the normal feed is performed.
High:
Reverse
Overview
High speed operation check of the Film Wind Up Motor
(DM3)/Ribbon Film Supply Motor
(DM4) (reverse direction)
Detail
Low speed operation check of the Film Wind Up Motor
(DM3)/Ribbon Film Supply Motor
(DM4) (reverse direction)
Use Case
Checking the operation
Adj/Set/Operate
Method
Select the item, and then press SET key.
Caution
Because the printer becomes operation failure, do not press the
SET key to stop during
operation. If it has been stopped, turn
OFF/ON the power switch.
Supplement/Memo
The motor control for the normal feed is performed.