Evolis Avansia - Page 96

Service Manual_AVA1_ENG-20220922_I 96
Card Setup >
Card Feed
Overview
Set of the card supply source
Detail
To set the card supply source.
Adj/Set/Operate
Meth
- od
1. Select the setting value.
2. Press the SET key, and then confirm the setting value.
Caution
The following movement is not applied.
• Print of the test print in the service mode
• Card feed operation in the service mode
• Test operation in the option connection mode
Display/Adj/
Set
Range
CARD CASETTE: Feed the cards from the card case.
RIGHT
(UNIT): Receive the cards from the option installed on the right
side.
Default Value
CARD CASETTE
Default Value
USER SETTING
Error Exit
Overview
Set of the exit for the print failure cards
Detail
To set the exit for the print failure cards
Card Setup >
Error Exit
Adj/Set/Operate
Meth
- od
1. Select the setting value.
2. Press the SET key, and then confirm the setting value.
Caution
The following movement is not applied.
• Print of the test print in the service mode
• Card feed operation in the service mode
• Test operation in the option connection mode
Display/Adj/
Set
Range
USER SETTING: Eject cards to the designated exit at [Normal Exit] in
user mode.
LEFT(STACKER): Eject the cards to the stacker through
the exit on the left side.
LEFT(UNIT): Deliver the cards to external
devices through the exit on the left side.
RIGHT(EJECT): Eject the
cards
through the exit on the right side (diagonally lower right).
RIGHT(UNIT):
Deliver the cards to external devices through the exit on
the
right side (horizontal).
Default Value
USER SETTING