Setup
228 FTBx-88000 Series
BERT and Unframed BERT
Pass/Fail Verdict check box when selected (cleared by default)
enables service disruption pass/fail verdict and allows setting the
threshold value.
SDT Threshold (ms) allows configuring the acceptable maximum
service disruption time before failing the test: 0.001 to 299999.999 ms
(default is 50 ms).
Multi-Pattern Configuration
Note: Only available for DSn/PDH BERT test application with DS1 signal (DS0
disabled) and when the pattern is Multi-Pattern.
The Multi-Pattern feature allows sending each pattern for a specific
duration, sequentially and continuously.
Pattern represents a sequence of patterns that will be generated: 1111,
1in8, 2in8, 3in24, and QRSS.
Enable check box allows enabling the generation of each pattern
individually in the pattern sequence. All patterns are enabled by
default. All 1’s (1111) is disabled for unframed test.
Individual Pattern Duration specifies the transmission duration of
each pattern: 15 s, 30 s, 45 s, 1 min, 2 min, 3 min (default),... up to
15 min.
Restore < Test Application > Defaults
Reverts the test application to its default factory settings.
To Next Page
Loading...
