Setup
330 FTBx-88000 Series
MAC/IP/UDP
MAC/IP/UDP
Note: Only available with Framed Layer 2 and higher.
From the Test menu, tap Setup, Test Configurator, and...
For RFC 2544 and EtherBERT, tap on the protocol block.
For EtherSAM, and Traffic Gen & Mon, tap on the protocol block, and
on the MAC/IP/UDP tab.
For FlexE BERT, tap on the Clients block, and on the MAC tab.
For eCPRI BERT, tap on the eCPRI FLow block, and on the MAC tab.
For DCO BERT, tap on the Client block, and on the MAC/IP/UDP tab.
Client, available with DCO BERT multiple link client (ex. 4 x 100GE),
allows selecting the client to be displayed.
Enable check box when selected (default), includes the selected
client in the test. At least one of the clients must remain enabled.
Link, available with EtherBERT multiple link interface (ex: 2 x 100GE),
allows selecting the link to be displayed.
Enable check box when selected (default) includes the selected link
in the test. At least one of the links must remain enabled.
Client ID, available with FlexE BERT, allows selecting the client
identification to be displayed.
Size (Gbit/s), available with FlexE BERT, indicates the size of the
client ID.
Stream selection, available with Traffic Gen & Mon, allows the
configuration of up to 16 streams individually by either using the
left/right arrow or by tapping over the stream numbers area then on a
specific number.
To Next Page
Loading...
