EXFO FTBx-88260 - Transceiver System (TA;TA4)

Setup
442 FTBx-88000 Series
Transceiver System (TA/TA4)
Transceiver System (TA/TA4)
Gives the transceiver system insertion counter and information on the
inserted transceiver system. Only available on 88260 and 88460 modules.
From the Test menu:
 For iOptics, tap Setup, Test Configurator, tap More... from the Device
Under Test block, and on the Transceiver System tab.
 For other tests, tap Setup, Test Configurator, tap on the interface
block and on the transceiver system (TA/TA4-...) tab.
 For TA-Sync, tap either:
 Setup, Test Configurator, tap on the clock block and on the
TA-Sync tab. This tab is not displayed when Ext Clock Out is set to
None.
 Setup, System and on the TA-Sync tab.
Port / Port A/B
Note: Port A/B on 88260 indicates on which port the transceiver system is
inserted.
 Transceiver System Insertion Counter indicates the number of time a
transceiver system has been inserted into this FTBx module port.
 Transceiver System Parameters are as follows:
 ID indicates the name of the transceiver system.
 Serial Number indicates the serial number of the transceiver
system.
 Revision indicates the hardware revision of the transceiver system.