Setup
Power Blazer 343
Network
Network
From the test menu tap Setup, Test Configurator, the interface block, and
the Network tab.
Note: For Through Mode test application, the Network tab is only available for the
Primary Port but the configured parameters apply to both ports.
Link, available with EtherBERT multiple link interface (ex: 2 x 100GE),
allows selecting the link to be displayed.
Enable check box when selected (default) includes the selected link
in the test. At least one of the links must remain enabled.
MAC
MAC Address indicates and allows changing, when the Factory
Default check box is cleared, the default and unique Media Access
Control (MAC) address given to the Ethernet port.
Factory Default check box when selected (default) indicates that the
factory source MAC address is used.
Frame Format (layer 2) allows selecting Ethernet II (default) or
802.3 SNAP as the frame format. Only Ethernet II is available with
25G/50G/200G/400G, multiple link interface, and eCPRI.
To Next Page
Loading...
