Test Results
624 FTBx-88000 Series
Summary - Time Error / Wander
Summary - Time Error / Wander
From the test menu, tap Results, and the Summary tab.
Note: With the G.8275.2 profile, the TE values are only available 200 seconds after
the test is started as the calculation method requires a sample selection
window of 200 seconds.
Test Status displays the current status of the test. The global test
pass/fail verdict is displayed next to the Test Status field when
enabled.
--: Idle state, the test is not running or results are not available.
In Progress: The test is running.
Completed: The test is completed, stopped at the planned time, or
manually stopped when there is no set timer.
Aborted: The test has been aborted either manually (Stop) or
automatically from an alarm/error:
Any signal/interface alarm.
REF-FAULT (reference signal alarm)
For G.8275.1 profile: Domain Mismatch, Loss Sync, Loss
Announce
Start Time indicates the date and time the test was started. The date
and time reset every time the test is restarted or reset.
Test Recovery, when displayed, indicates that the test has
automatically recovered from a power failure. The number of
occurrences is also displayed next to the Test Recovery field. Refer to
Power Failure Recovery on page 789.
Logger Full, when displayed, indicates that the logger is full. Refer to
Logger on page 496.
To Next Page
Loading...
