EXFO FTBx-88260 - Services - L2 CP

Setup
396 FTBx-88000 Series
Services - L2CP
Services - L2CP
The EtherSAM test application supports the configuration of up to 10
different services individually. All parameters are configurable per service.
From the Test menu, tap Setup, Test Configurator, tap on the services
block, and on the L2CP tab.
Service Selection and L2CP Handling Test
 Service Name indicates the name to the selected service. Select the
service to be configured by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific
service number. An orange background indicates the selected service
while a green background indicates the services that are enabled.
 L2CP Handling Test check box when selected (default) enables the
L2CP Handling test for the selected service.
Table
The following parameters are displayed and/or configurable per service.
 Check boxes:
The first check box (top-left) allows enabling/disabling all L2CP frames
at once.
The check box in front of each L2CP name allows enabling/disabling
each L2CP frame individually; enabled by default for predefined
frames and disabled for user defined frames.
 Name indicates the name of each L2CP frame.
 Destination MAC address indicates the L2CP frame destination MAC
address.
 Expected L2CP Handling selects the expected L2CP handling for each
L2CP frame: Pass Through (default) or Discard/Peer.