Setup
346 FTBx-88000 Series
Network / Network Details - iSAM
Network / Network Details - iSAM
From the test menu, tap Setup, Test Configurator, and the More button
from the Network block.
Network Block
The Network block, available before clicking on the More button, allows
configuring the basic network settings, click on More for all settings.
The total bandwidth (when the Performance Test is enabled) and the
estimated test duration are displayed.
NAT LAN/WAN indicate presence of NAT (Network Address Translation)
router. The NAT router is automatically detected and graphically displayed
with LAN/WAN indication.
When there is a NAT at the remote site, it is required to create UDP/TCP port
62819 forwarding rule on this NAT router to allow DTS communication. In
addition, when there is a NAT in both directions (L->R and R->L), it is
required to create port forwarding rules on the NAT router located at the
remote side for UDP port 7.
iSAM
Layer is the layer used for all services. The layer is fixed to L3/L4 when the
RFC 6349 Test on Service 1 is enabled.
L2 (default) for Ethernet II.
L3/L4 for Ethernet II, IP (IPv4), and respectively UDP for the Configuration
and Performance subtests, and TCP for RFC-6349 subtest.
Classification defines the traffic classification used in the provider
network: VLAN ID, VLAN Priority, or DSCP (available with layer L3/L4).
Note: At least one check box (Configuration Test, or Performance Test, or
RFC 6349 Test on Service 1) has to be selected.
To Next Page
Loading...
