Setup
Power Blazer 365
Remote Details - iSAM
Remote Details - iSAM
The remote block automatically scans the remote modules for DTS and
Remote Loopback modes and allows the selection of the remote module
that is used to loop back the traffic via Smart Loopback or EtherSAM in
Dual Test Set (DTS) mode for simultaneous bidirectional results. If the
connection with the remote module is not manually established, the
remote connection process is automatically performed when starting the
test.
From the test menu, tap Setup, Test Configurator, and the More button
from the Remote block.
Note: Not available with Manual Loopback remote operation mode.
For both DTS and Remote Loopback Operation
Modes
Discovered Remotes
The modules are discovered dynamically and listed with their Name,
IP address, Status, Connection, and Preferred information. Name and
Status are only available for remote 88000 Series, and 85100G
modules. Only modules from the same subnet are automatically
discovered. To access a module from a different subnet, use the Add
button.
To Next Page
Loading...
