EXFO FTBx-88260 - Laser ON;OFF

Pop-Up
Power Blazer 981
Laser ON/OFF
Note: For LLC frame format, the following concatenated values of
DSAP/SSAP/Control are not valid since they are reserved for SNAP frame
format: 0xAAAA03 or 0xABAB03.
 OUI (available with SNAP frame format): 0x000000 (default) to
0xFFFFFF.
 EtherType (available with SNAP and Ethernet II frame formats):
0x0000 to 0xFFFF for SNAP and 0x0600 to 0xFFFF (excluding 0x8100,
0x88A8, 0x9100, 0x9200, 0x9300, 0x8847, and 0x8848) for Ethernet II.
Default is 0x0600.
 Subtype, only available for some predefined L2CP frames, indicates
the subtype for the frame.
 Custom Bytes (16 bytes) 0x00000000000000000000000000000000
(default) to 0xFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF. Only available
for user defined L2CP frames.
Laser ON/OFF
Laser ON/OFF button, available with parallel interfaces, is used to activate
the laser control per optical lane or for all lanes. Select the Laser check
box to enable/disable the laser for each lane individually or select the All
Lanes check box to enable/disable all optical lanes at once. Not available
with 50GE.