Setup
Power Blazer 271
EtherSAM - Global
EtherSAM - Global
From the test menu, tap Setup, Test Configurator, tap on the test block,
and on the Global tab.
Dual Test Set
Dual Test Set (DTS) check box when selected (cleared by default)
enables the Dual Test Set testing mode. Once Dual Test Set is
enabled, use the Discover Remote button to select a remote unit. Not
available in Dual Port topology.
Note: It is also possible using the Discover Remote button to connect to a remote
unit and automatically enable Dual Test Set. For more details, refer to
Discover Remote on page 764.
Disconnected indicates that there is no connection established with a
remote unit.
NAT LAN/WAN and WAN IP indicate presence of NAT (Network Address
Translation) router. The NAT router is automatically detected and
graphically displayed with LAN/WAN indication as well as the WAN IP
address when the unit is behind a NAT router.
Note: When there is a NAT at the Remote site, it is required to create UDP/TCP
port 62819 forwarding rule on this NAT router to allow DTS communication.
In addition, when there is a NAT in both directions (L->R and R->L), it is
also required to create port forwarding rules on the NAT router located at
the Remote side for every service defined.
Discover Remote allows discovering remote unit supporting Remote
Loopback and/or Dual Test Set. For more details, refer to Discover
Remote on page 764.
To Next Page
Loading...
