EXFO FTBx-88260 - BERT and Unframed BERT - Ecpri

Setup
Power Blazer 233
BERT and Unframed BERT - eCPRI
BERT and Unframed BERT - eCPRI
From the test menu, tap Setup, Test Configurator and tap on the BERT or
Unframed BERT block.
Pattern
The icon next to the Pattern label indicates the status of the received
pattern signal. Refer to Status Bar on page 40 for more information.
 Coupled RX to TX check box, when selected (default and dimmed),
couples both the TX and RX signal with the same test pattern.
 No Pattern Analysis (Live) check box when cleared (selected by
default), monitors the incoming traffic pattern and Round-Trip Latency.
For live traffic, the No Pattern Analysis (Live) check box should be
selected as the traffic is a live pattern and in this case no monitoring is
required.
 TX Pattern / RX Pattern indicates PRBS31 as the test pattern for each
direction and is not configurable.
 Invert check box, when selected (cleared by default), inverts the
generated/expected test pattern meaning that every 0 will be changed
for 1 and every 1 for 0. For example, the pattern 1100 will be sent
as 0011.
 Invert check box, when selected (cleared by default), inverts the
generated/expected test pattern meaning that every 0 will be changed
for 1 and every 1 for 0. For example, the pattern 1100 will be sent
as 0011.