Setup
Power Blazer 329
Local Details - iSAM
IP
IP Version is set to IPv4 and dimmed.
Automatic IP (DHCP) check box when selected (cleared by default)
allows obtaining an IP address dynamically from a DHCP (Dynamic
Host Configuration Protocol) server.
Note: IP Address, Subnet Mask, and Default Gateway are not configurable
when the Automatic IP (DHCP) check box is selected.
IP Address allows entering the source IP address for the stream. The
default setting is 10.10.x.y, where x and y are respectively the two least
significant bytes of the port default MAC address.
Subnet Mask allows entering the Subnet Mask (default is 255.255.0.0).
Default Gateway check box when selected (cleared by default) allows
entering a default Gateway IP address (default is 0.0.0.0).
Remote Discovery ID
Remote Discovery ID is used to easily identify this module in case another
module is performing a discovery scan. Up to 16 alpha-numeric characters
are allowed.
To Next Page
Loading...
