Setup
Power Blazer 275
EtherSAM - Global
Global Options
Per Direction Configuration check box when selected (default)
specifies that the values can be configured independently for each
direction (local to remote and remote to local) for Dual Test Set or for
each port direction for Dual Port; for Dual Port using a different rate
on each port, the check box is forced selected. When the
Per Direction Configuration check box is cleared the configuration
will be coupled and the values apply to both directions/ports. For Dual
Test Set the Per Direction Configuration is only available when the
communication with the remote unit is established.
Pass/Fail Verdict check box when selected (default) enables the
pass/fail verdict. A global pass/fail verdict is given for the EtherSAM test,
Service Configuration Test, and Service Performance Test (for each
service). The pass/fail verdict is based on the following criteria: Frame
Loss, Max Jitter, Round-Trip Latency, and Average - RX Rate.
Latency Measurement Mode, available with Dual Test Set, allows the
selection of the latency measurement mode: Round-Trip (default) or
One-Way (for rates from 10M to 10GE).
Synchronization with 1PPS interface/reference is required to perform
One-Way Latency measurement. One-Way Latency is only possible
when both local and remote 1PPS signal clocks are valid. The
following alarms are available with One-Way Latency measurement.
LOPPS-L and LOPPS-R (Loss Of Pulse Per Second - Local/Remote) are
declared when either no pulse is received or when no pulse is
received within 1 second ± 6.6 µs after the previous pulse. LOPPS-R is
only monitored once the DTS connection is established.
Restore EtherSAM Defaults
Reverts the test application to its default factory settings.
To Next Page
Loading...
