Setup
306 FTBx-88000 Series
Interface
Remote Fault Emulation check box when selected, generates Remote
Fault ordered sets when a Link Fault is received. Available for rates
10GE and up with EtherBERT (all framing at the exception of
Unframed (Interop)), Traffic Gen & Mon (framed), and eCPRI
(framed).
Auto-Negotiation check box when selected (default), available with
10/100/1000M Electrical and 1GE Optical interfaces, indicates to the
remote port which parameters to use. For 1GE Electrical interface and
when using an active copper SFP, the Auto-Negotiation check box is
selected and dimmed.
Note: When the Auto-Negotiation check box is selected, the port Speed, Duplex,
Flow Control, and Local Clock parameters can be set. Those settings are
not applied immediately to the port, they are used only when the
negotiation process is started and take effect only when the
auto-negotiation succeeds. However current settings are applied
immediately to the port when the Auto-Negotiation check box is cleared.
Speed, available with 10/100/1000M Electrical interface, allows the
selection of the interface rate: 10M, 100M, 1GE, or Auto. Auto is only
available when the Auto-Negotiation check box is selected. The
negotiated speed will be displayed next to the Speed field selection.
The 10M speed is not available with SyncE test application.
Duplex is configurable for 10M and 100M electrical interfaces and
choices depend on the test application: Full Duplex (default), Half
Duplex, or Auto (available when the Auto-Negotiation check box is
selected). For other rates the duplex is set to Full Duplex. Half Duplex
is not available with an active copper SFP. The negotiated duplex will
be displayed next to the Duplex field selection.
Flow Control is configurable and choices depend on the test
application: Enable TX, Enable RX, Enable RX and TX, None
(default), or Auto (available when the Auto-Negotiation check box is
selected). When the Flow Control is set to None, pause frames
received are ignored.
To Next Page
Loading...
