Test Results
584 FTBx-88000 Series
Summary - Path OAM - FlexE BERT
Connectivity Verification
Note: Only CV multi-block messages with valid CRC4 and containing the
ascending sequence 0 to 7 are monitored.
Status
--: CV Function is disabled or CV messages have either never been
received or more than 1.5 minutes have elapsed since the last CV
message received.
SAPI Mismatch: SAPI Mismatch alarm is active.
DAPI Mismatch: DAPI Mismatch alarm is active.
SAPI/DAPI Mismatch: SAPI Mismatch and DAPI Mismatch alarms
are active.
Normal: CV messages are being received without alarms.
TX CVM indicates the count of transmitted CV Messages.
RX CVM indicates the count of received CV Messages.
SAPI displays the received SAPI message and allows configuring the
expected message when the Expected check box is selected from
setup: EXFO SAPI by default. A maximum of 16 characters is allowed.
The default message contains a NULL (all 0’s) character preceding it
and NULL (all 0’s) characters are automatically appended to the
message for bytes that are not defined.
DAPI displays the received DAPI message and allows configuring the
expected message when the Expected check box is selected from
setup: EXFO DAPI by default. A maximum of 16 characters is allowed.
The default message contains a NULL (all 0’s) character preceding it
and NULL (all 0’s) characters are automatically appended to the
message for bytes that are not defined.
To Next Page
Loading...
