Alarms/Errors
936 FTBx-88000 Series
Alarms
PLM-P (Payload Label Mismatch - Path) for WIS, indicates that five
consecutive frames have mismatched STS signal labels.
PLM-P/UNEQ-P (Payload Label Mismatch - Path / Unequipped - Path)
check box when selected (cleared by default) enables the Signal Label
Mismatch for the expected message defined as well as UNEQ-P
monitoring.
PLM-V / LP-PLM (Payload Label Mismatch) for SONET/SDH, indicates
that five consecutive superframes with mismatched VT/LP Signal (bits
5 through 7 of the V5 byte are “000”, “001” or “111”). Only available
when the PLM-V/UNEQ-V / LP-PLM/LP-UNEQ check box is selected
(refer to page Labels on page 321).
QL Mismatch for 1588 PTP, indicates that the received QL value does
not match the Expected QL. The QL Mismatch alarm is only reported
when at least one Announce message has already been received (Last
QL Received) and that the QL Mismatch Monitoring check box is
selected. Only supported with the 1588 PTP test application.
QL Mismatch for SyncE with the QL Mismatch Monitoring check box
selected, indicates that received QL does not match the Expected QL
value configured.
R Deg SER (Remote Degraded SER) for Ethernet 200/400GE with FEC
Degraded SER enabled, indicates that a remote degraded SER signal
is detected.
R Deg SER (Remote Degraded SER) for FlexE PHY with 200GE/400GE
when FEC Degraded SER is enabled, indicates that a remote
degraded SER signal is detected.
R-LOF (Remote - Loss Of Frame) for CPRI, indicates that bit 4 of the
Z.130.0 byte is set to 1.
R-LOS (Remote - Loss Of Signal) for CPRI, indicates that bit 3 of the
Z.130.0 byte is set to 1.
RAI (Remote Alarm Indication) for CPRI, indicates that bit 1 of the
Z.130.0 byte is set to 1.
To Next Page
Loading...
