Alarms/Errors
Power Blazer 949
Errors
BIP-8 (Bit Interleave Parity-8) for OTU, indicates that SM BEI errors are
received from the DUT (value 0 to 8).
BIP-8 (Bit Interleaved Parity - 8) for Path OAM, indicates a BIP-8
mismatch between the received value and the locally computed value.
Bit Error indicates that there are logic errors in the bit stream (i.e.,
zeros that should be ones and vice versa). Only the count and rate
values are reported for unframed test 40GE/OTU3 and up.
Block for Ethernet 10G LAN/WAN interface, indicates that error block is
received in frames.
Block for parallel Ethernet interfaces and 100 GbE over OTU4,
indicates that invalid 64b/66b block code are received. An invalid
64b/66b block is declared when the synchronization field has a value of
00 or 11. Injection is not available at 100GE when RS-FEC is enabled.
Block for Fibre Channel 10X/16X, indicates the number of frames
received with an errored block condition.
BPV (Bipolar Violation) for Interface DS1/DS3/STS-1e, indicates that
pulses of the same consecutive polarity were detected, in violation
with the bipolar signal format. Available with DS1, DS3, and STS-1e.
Cm-CRC-6 for FlexO GMP, indicates that there is a Cm-CRC-6 mismatch
between the received value and the locally computed value. Available
with FlexO.
Cm-CRC-8 for GMP, indicates that there is a Cm-CRC-8 mismatch
between the received value and the locally computed value.
CnD-CRC-5 for GMP, indicates that there is a CnD-CRC-5 mismatch
between the received value and the locally computed value.
CnD-CRC-9 for FlexO GMP, indicates that there is a CnD-CRC-9
mismatch between the received value and the locally computed value.
Available with FlexO.
Collision for Ethernet 10/100 Mbit/s electrical interface in Half Duplex
mode, indicates the number of collisions on the link.
To Next Page
Loading...
