Extra 300LT - Bottom Hinge Bellcranks; Bottom Hinge Bracket; Control Cable

CHAPTER 27
PAGE 20
PAGE DATE: 21. March 2014
MAINTENANCE MANUAL EXTRA 300LT
27-20-02 Bottom Hinge Bracket
Removal/Installation
1 Remove the rudder per Chapter 27-20-01.
2 Loosen the attachment bolts.
3 Remove the bottom hinge bracket with the travel stop plate.
4 Install in reverse sequence of removal.
27-20-03 Bottom Hinge Bellcranks
Removal/Installation
1 Remove the rudder per Chapter 27-20-01.
2 Loosen the attachment bolts.
3 Remove the bottom hinge bellcranks.
4 Install in reverse sequence of removal.
27-20-04 Control Cable
Removal
1 Remove the respective access panels
2 Remove the cable to fuselage attachment bolts.
3 Remove the cable to rudder bellcrank attachment bolts.
4 Cut the control cables behind the front shrinking sleeves
and behind the cable to cable connection.
5 Remove the control cable parts by pulling out to the back.
Installation
Use only control cables manufactured by EXTRA Flugzeug-
produktions- und Vertriebs- GmbH. Those cables are prepared
for simple installation.