CHAPTER 33
PAGE 8
PAGE DATE: 21. March 2014
MAINTENANCE MANUAL EXTRA 300LT
33-40-20 Landing Light System
A Xenon landing light (1) consisting of a hood (10), a glass
(11) and the head lamp (6) is integrated in the RH bottom half
of the engine cowling. It is energized by a power supply box
(2) installed LH inside the lower cowling next to the firewall.
The electrical wiring (3) connecting the landing light and the
power supply box is fastened with cable straps (9) and cable
retainers to the bottom half of the engine cowling. It features
a plug-and-socket connection on each side (8, 13). Between
firewall feed through and the power supply there is a further
plug-and-socket connection (14, 15).
N O T E When the cowling shall be removed the plug (15) must
be disconnected.
The system is controlled by the LANDING LIGHT switch
and is protected by the LANDING LIGHT circuit breaker
both located on the aft right instrument panel (see Chapter
31-10-00).
33-40-21 Landing Light
Removal/Installation
1 BATTERY switch OFF.
2 Remove engine cowlings as per Chapter 71.
3 Disconnect the plug (8) from the head lamp (6) using the
spring (7).
4 Remove the attachment bolts (4) and remove the hood (10)
and the glass (11) which is located under the hood.
5 Install in reverse sequence of removal.
To Next Page
Loading...
