Extra 300LT - Bottom Fuselage Cover; Forward View on Bottom Side Firwall

CHAPTER 53
PAGE 11
PAGE DATE: 7. July 2010
MAINTENANCE MANUAL EXTRA 300LT
53-00-04 Bottom Fuselage Cover
Removal
1 Remove engine cowling as per Chapter 71, the landing gear
cuffs and main fuselage cover in accordance with this chapter.
2 Pull the plug of OAT sensor wiring.
3 Disconnect the antenna wiring.
4 Remove bottom fuselage cover by removing the attachment
screws.
Installation
I M P O R T A N T The cockpit area must be thoroughly sealed and thus
separated from the engine compartment. Gases or fluids
could get into the cockpit area.
Critical areas to be observed are the following:
Position A and D of Figure 7, where different parts converge
(firewall, aluminium profile, bottom fuselage cover and
exhaust area covering sheet)
Position B and C, where a bent corner ends in a bore hole.
Figure 7 Forward View on Bottom Side Firwall
1 Position bottom fuselage cover in its original position.
2 Plug the OAT sensor wiring.
3 Connect the antenna wiring.
4 Install bottom fuselage cover attachment screws.