Extra 300LT - Page 389

CHAPTER 61
PAGE 9
SERVICE MANUAL EXTRA 300LT
PAGE DATE: 12. June 2015
Rigging
1 Move vernier control knob (8, Figure 2) to the foremost
position.
2 Check that the travel stop at the governor control lever is
reached, and the over-travel of 5mm [3/16"] (tolerance +/-1
mm [1/32"]) is ensured at the rpm control knob (see figure
2).
3 Check full travel.
4 If necessary adjust rod end (1, figure 2) by the following
steps:
a Remove cotter pin, castle nut, washers and bolt from the
rod end (1) to governor control lever (2) attachment.
b Loosen the counter nut and adjust rod end (1) by turning.
Ensure thread is visible in the inspection hole when
fastening. Apply inspection lacquer on the counter nut.
c Reconnect the rod end (1) to the governor control lever (2).