CHAPTER 71
PAGE 9
SERVICE MANUAL EXTRA 300LT
PAGE DATE: 24. February 2017
2 Unscrew locknut of the mounting bolt at one shock mount
(ref. figure 3).
3 Push bolt backwards to remove it.
4 Remove forward half of the shock mount.
5 Remove tubular spacer.
6 Extract aft half of the shock mount. If necessary, lower
respectively lift the engine a little to get the needed
clearance for removal of the aft shock mount half.
Installation
Install in reverse sequence of removal
Torque locknuts of connection bolts with 55 Nm (40.5 ft.
lbs.).
To Next Page
Loading...
