Operating manual.
CNC 8060
CNC 8065
4.
AUTOMATIC MODE
Executing program blocks separately.
·102·
(REF: 1807)
4.4 Executing program blocks separately.
From the automatic mode, it is possible to execute blocks of a program separately; i.e. it is
possible to select a block of the program and execute only that block. Blocks executed like
this change the history of the M and G functions.
Press the "EXBLK" softkey of the horizontal menu to enable this function. Being this option
active, every time the [START] key is pressed, it only executes the block selected in the active
program. Once that block is executed, another block may be executed by selecting it with
the cursor and pressing [START] again and so on. The blocks may be selected with the []
[] keys.
To Next Page
Loading...
