Operating manual.
CNC 8060
CNC 8065
SETUP ASSISTANCE
22.
Oscilloscope
·405·
(REF: 1807)
22.1.3 Configuration screen
The configuration screen may be accessed with the horizontal softkey "CONFIG". This
screen looks like this with two clearly different areas. The left side shows the data of the
variables to be displayed, the trigger data and the time base. The right side shows the
parameters to be acted upon and the amount to increase/decrease the values of those
parameters.
Selection of the variables to be displayed, trigger and time base
It is the area where the user selects the variables to be displayed at the graphics window,
the trigger options and the time base. Up to 4 variables may be displayed at the same time.
When typing the name of any variable incorrectly, the CNC will show the error "Access
denied".
Besides the trigger data and the base time, this window may be used to select the color used
to display the variable and whether it will be visible or not.
The sampling period.
The sampling period must be multiple of the machine parameter LOOPTIME; if a wrong value
is entered, the CNC will set it to the right one.
When capturing only two variables of the same drive, it is possible to set a sampling time
shorter than LOOPTIME. In this case, the sampling period must be multiple of 0.0625 ms
which is the minimum allowed. Not all the variables of the drive accept this sampling time.
The CNC will issue an error message when trying to represent a wrong variable.
Parameter selection and increase/decrease
It is the area where the user selects the parameters upon which to act. To the right of each
parameter, there is a square used to increase/decrease of its value.
This way, when the focus is on the value of a variable on the main screen, pressing the vertical
softkey "V+" will increase the parameter value in the amount set on the configuration screen.
By default, the increase/decrease value of a parameter is initialized to 1.
To Next Page
Loading...
