Operating manual.
CNC 8060
CNC 8065
·33·
(REF: 1807)
RETURNING CONDITIONS
Pack it in its original package along with its original packaging material. If you do not have the original
packaging material, pack it as follows:
1 Get a cardboard box whose 3 inside dimensions are at least 15 cm (6 inches) larger than those of the
unit itself. The cardboard being used to make the box must have a resistance of 170 Kg (375 lb.).
2 Attach a label to the device indicating the owner of the device along with contact information (address,
telephone number, email, name of the person to contact, type of device, serial number, etc.). In case
of malfunction also indicate symptom and a brief description of the problem.
3 Protect the unit wrapping it up with a roll of polyethylene or with similar material. When sending a central
unit with monitor, protect especially the screen.
4 Pad the unit inside the cardboard box with polyurethane foam on all sides.
5 Seal the cardboard box with packaging tape or with industrial staples.
To Next Page
Loading...
