Operating manual.
CNC 8060
CNC 8065
PLC
20.
"Programs" service
·345·
(REF: 1807)
20.2.2 Softkey menus. Files of the PLC project.
When selecting a program of the PLC project at the service window, the softkey menu will
offers the following options.
Softkey. Description.
Files of the PLC project "Edit". This softkey shows the editing window. See
"20.3 Program editing" on page 346.
Files of the PLC project "Monitoring". This softkey shows the monitoring window. See
"20.6 Program monitoring" on page 359.
Files of the PLC project "Eliminate". This softkey deletes the selected file of the PLC
project (the file will still be available in the CNC's hard disk).
Files of the PLC project "Rename". This softkey may be used to change the name
of the selected file.
Files of the PLC project "Copy". This softkey may be used to make a copy of the
selected file. When selecting this option, the CNC shows a list with the programs
stored at the CNC. To make a copy of the file:
(1) Select the destination folder for the copy.
(2) Define the file name at the bottom window. To replace an existing file, select it
from the list.
(3) Press [ENTER] to copy the file or [ESC] to cancel the selection and close the file
listing.
Files of the PLC project "Move up" When the PLC project contains several files, this
softkey may be used to move the selected file up.
Files of the PLC project "Move down" When the PLC project contains several files,
this softkey may be used to move the selected file down.
To Next Page
Loading...
