Operating manual.
CNC 8060
CNC 8065
4.
AUTOMATIC MODE
Display the status of the program or of the active subroutines.
·88·
(REF: 1807)
4.2 Display the status of the program or of the active subroutines.
From the horizontal softkey menu, it is possible to toggle between the display of program
blocks and the display of information related to the status of the subroutines, canned cycles,
repetition blocks and loops.
Having this option active and the program execution interrupted, the user can use the cursor
to select an information line and press [ENTER] to skip to the corresponding program block.
Description of the information displayed.
The information is laid out in a table with four columns and having the following meaning.
The window shows the following information.
Column. Meaning.
S Nesting level of the subroutine.
P Nesting level of the local parameters used in the subroutine.
Sub Name of the program, subroutine or canned cycle.
Op Type of block being simulated. The loops are shown with a progress bar and a
text indicating the loop it is in.
Type of block. Information displayed.
L Name of the subroutine
LL Name of the subroutine
#CALL Name of the subroutine
#PCALL Name of the subroutine
#MCALL Name of the subroutine
G180 through G189 Name of subroutine associated with the G function.
M function. Name of the subroutine associated with the M function.
T function. Name of the subroutine associated with the T function.
Canned cycle. G function associated with the canned cycle.
#EXEC Name of the subroutine
$RPT Number of current loop and total number of loops.
$FOR Number of current loop and total number of loops.
$WHILE Number of current loop.
$DO Number of current loop.
$IF Text "IF".
$SWITCH Text "SWITCH".
To Next Page
Loading...
