Operating manual.
CNC 8060
CNC 8065
PLC
20.
Editing in C language or mnemonic language.
·351·
(REF: 1807)
20.4.5 Softkey "Find/Replace".
This softkey is used to find a line or a text in the program and replace a text with another
one. When selecting this option, the CNC shows a dialog box requesting the line number
or the text to look for. When defining a text search, certain options may also be defining that
allow:
A Go to a line of the program.
B Replacing the text being searched with another in the program.
C Ignore uppercase and lowercase.
D Consider the text to find as a whole word.
E Select whether the search starts at the beginning of the program or at the cursor position.
F Direction of the search.
After defining the search options, press [ENTER] to start the search or [ESC] to cancel it.
The text found in the program will be highlighted and the softkey menu will show the following
options:
• "Replace" option, to replace the highlighted text.
• "Replace all" option, to replace the text throughout the whole program.
• "Find next" option, to skip this text and keep on searching.
• "Find previous" option, to look for the text without replacing it.
To end the search, press [ESC].
To Next Page
Loading...
