Operating manual.
CNC 8060
CNC 8065
SETUP ASSISTANCE
22.
The circularity (roundness) test
·425·
(REF: 1807)
22.3.4 Configure the graphic environment
This operation may be carried out before or during the test. If they are modified during the
test, the screen is cleared and the graphic representation goes on.
The following graphic characteristics may be defined from the data window.
• Number of divisions on both sides of the theoretical circle.
• Scale or value in microns of each division.
• Error margin. Percentage of the area that is occupied by the error margin (divisions area).
Initialize the data
When accessing the circularity test, it assumes the values used last. Pressing the "Initialize"
softkey restores the default values.
Number of divisions 5
Scale: 10 microns/division
Error margin: 50 %
Bear in mind that the softkey Initialize initializes all the data of the window, including the values of the
machine parameters.
To Next Page
Loading...
