Fagor CNC 8060 - Softkey View

Operating manual.
CNC 8060
CNC 8065
PLC
20.
Editing in contact (ladder) language (softkeys).
·357·
(REF: 1807)
Edit "Negate"
This softkey negates the consultation_contact selected with the cursor.
20.5.4 Softkey "View".
View "Zoom +"
Increase the size of the font as well as the height and width of the contacts.
View "Zoom -"
Reduce the size of the font as well as the height and width of the contacts.
View "Cell +"
Increases the width of the contacts.
View "Cell -"
Reduce the width of the contacts.
20.5.5 Softkey "Marks".
Marks "Set / remove"
Place a mark or remove the mark of the block where the cursor is located.
Marks "Next mark"
Place the cursor on the next marked block.
Marks "Previous mark"
Place the cursor on the previous marked block.
Marks "Remove all"
Remove all the marks.
NOT M100 = CNCRD(A.POS.X, R100, M100)
M100
CNCRD
A.POS.X
M100
R200
This softkey may be used to enlarge or reduce the size of the contacts and of the text. When
selecting this option, the softkey menu shows the available options. To return to the main
menu, press the [BACK] key.
BACK
This softkey may be used to add or remove follow-up marks in the program. When selecting
this option, the softkey menu shows the available options. To return to the main menu, press
the [BACK] key.
BACK