Operating manual.
CNC 8060
CNC 8065
EDISIMU MODE (EDITING AND SIMULATION)
8.
Graphic assistance for the program editor.
·185·
(REF: 1807)
8.5 Graphic assistance for the program editor.
While editing the program, this window shows the 2D geometry of the program or of the profile
being edited. The window shows the geometry from the first block of the program or of the
profile up to the block selected with the cursor.
This window only shows 2D geometry, that of the work plane, ignoring coordinate
transformations, RTCP, scaling factors, mirror images, etc. To take these elements into
consideration, run a simulation of the program. When simulating a program, the CNC
replaces this window with the graphics window.
During execution, the window displays the elements as follows:
• The tool path generated by the block selected with the cursor is shown as a red solid line.
• The resolved elements are shown in a gray dashed line.
• The partially resolved blocks (such as circles or straight lines), if any, are shown as a a
yellow dashed line.
• The canned cycles are shown as a circle at the starting point of the cycle. The radius of
the circle will be the same as the radius of the programmed tool.
• If the cursor is inside a profile or ProGTL3 macro, the window shows the profile defined
between G841-G842, and G840 or the line selected with the cursor. If the cursor is not
in a profile that begins with G841-G842 or with #PROFILE BEGIN, the window shows
the entire previous geometry.
To Next Page
Loading...
