Operating manual.
CNC 8060
CNC 8065
AUTOMATIC MODE
4.
Display the status of the DMC (Dynamic Machining Control).
·113·
(REF: 1807)
4.9 Display the status of the DMC (Dynamic Machining Control).
4.9.1 DMC status and progress.
During the execution of a program while DMC is active, the automatic mode can display the
status and progress of this function; to do this, on the “Display” softkey of the horizontal menu,
select the option "DMC". To return to the standard screen in automatic mode, select the
“Standard” option on the same softkey. The data displayed on the DMC page are the same
as on the standard page, except for those for DMC itself (in the upper left corner).
A DMC status; ON/OFF.
B DMC override. The consumption bar limits will be those defined in the machine
parameters. The override applied by DMC is shown on the right.
C Feed per tooth. The consumption bar limits are the values programmed in the instruction
#DMC ON (FZMIN and FZMAX commands); if they have not been programmed, the
CNC does not display this bar.
D Power consumed by the spindle (defined as the percentage of rated power).
E Power consumed by the spindle under ideal conditions;
"target power" + "no-load power".
F Target power or ideal cutting power (defined as a percentage of rated power); learned
power or power programmed in the instruction #DMC ON (PWRSP command).
G No-load power (defined as a percentage of the rated power).
H Time saved by the DMC action.
I When DMC is active, the program history will display "DMC" and will not change, even
though the CNC performs incompatible functions that temporarily deactivate DMC.
J Final override (DMC override + switch override).
Automatic mode. DMC status and progress.
To Next Page
Loading...
