Fagor CNC 8060 - Examples of How to Define Profiles

Operating manual.
CNC 8060
CNC 8065
11.
PROFILE EDITOR
Examples of how to define profiles.
·218·
(REF: 1807)
11.7 Examples of how to define profiles.
11.7.1 Profile editor. Example 1 (milling).
Profile definition without rounding, chamfers or tangential entries and exits.
Definition of rounding, chamfers and tangential entries and exits
Select the "Corners" option. Press [ESC] to quit the "Corners" option.
End of editing
Select the "END" option and save the profile. The CNC quits the profile editor and inserts
the profile in the part-program.
Section. Geometry.
Starting point X = 80 Y =-20
Straight X = 80 Y =20
Straight X = 20 Y =20
Straight X = 20 Y = 80
Straight X = 60 Y = 80
Counterclockwise arc X = 100 Y = 80 Center X = 80
Center Y = 80
Radius = 20
Straight X = 140 Y = 80
Straight X = 140 Y =20
Straight X = 80 Y =20
Straight X = 80 Y =-20
Corner
Tangential entry Select point "1" Assign radius = 5
Chamfer Select point "2" Assign size = 10
Rounding Select point "3" Assign radius = 10
Rounding Select point "4" Assign radius = 5
Rounding Select point "5" Assign radius = 5
Rounding Select point "6" Assign radius = 10
Chamfer Select point "7" Assign size = 10
Tangential exit Select point "1" Assign radius = 5