Operating manual.
CNC 8060
CNC 8065
UTILITIES MODE
19.
Data safety backup. Backup - Restore
·337·
(REF: 1807)
19.6 Data safety backup. Backup - Restore
This option may be used to make a backup of the CNC configuration (OEM and user data)
to be restored later one if necessary. Backup/restore is not possible while the CNC is in
execution.
Make a backup of CNC data.
Data backup may be carried out when the CNC has been started up in SETUP mode or in
USER mode.
On Windows explorer, select the folder where the backup will be saved. Press the "BACKUP"
softkey and the CNC will display a window with the options to select the data to include in
the backup.
Restore data from the backup .
OEM data may only be restored whe the CNC has been started up in SETU mode; if it has
been started up in USER mode, only user data may be restored and the rest of the options
are disabled. The restore option is protected by the "Machine parameters" password.
On Windows explorer, select the folder where the backup has been saved. Press the
"RESTORE" softkey and the CNC will display a window with the options to select the data
to include in the backup. If the selected folder does not contain one of the backups, its option
will appear disabled. The CNC application must be restarted after restoring a backup.
Select the data to be included in the backup or restore.
The selected options will be kept until they are modified.
The CNC only allows doing the backup or restore when there is no power (e.g. E-stop button pressed).
Softkey. Meaning.
Make a backup of CNC data.
Restore data from the backup .
To Next Page
Loading...
