CNC 8060
CNC 8065
18
·293·
(REF: 1807)
TOOL AND MAGAZINE TABLE
18.1 Presentation of the tool tables and magazine tables.
• Tool table.
• Active-tools table.
• Table for the status of the tool change process.
• Tool magazine tables.
In order to load a tool in the magazine or in the spindle, that tool must have been previously
defined in the corresponding table of the CNC.
This operating mode consists of several tables. The various tables may be selected using
the horizontal softkeys. If while one of the tables is selected, the [BACK] key is pressed, that
table will be deselected.
To Next Page
Loading...
