Operating manual.
CNC 8060
CNC 8065
13.
GRAPHICS HD (·M· MODEL).
Actions. Print the graphic.
·246·
(REF: 1807)
13.11 Actions. Print the graphic.
Print the graphic.
This softkey may be used to print the graphics in the pre-determined printer or save it as a
file (bmp format) at the CNC. When printing the graphic to a file, it will be saved in the folder
"..\Users\Reports\"; the file name may be selected using the "Print configuration" softkey.
When selecting this option, the CNC will show a dialog box requesting the print destination
(printer or file). After selecting the destination, press [ENTER] to print it or [ESC] to cancel it.
Print configuration.
This softkey may be used to set the printing properties. When selecting this option, the CNC
shows a dialog box where the following may be defined:
• The title of the graphics that will appear next to it in the print.
• The name of the file where the graphics will be stored when printing out to a file.
After filling out the data, press [ENTER] to accept them or [ESC] to cancel them.
13.12 Delete the graphic.
This option may be used to print the graphic out to the predetermined printer or out to a file.
This softkey deletes the tool paths and resets the solid to its initial dimensions.
To Next Page
Loading...
