Operating manual.
CNC 8060
CNC 8065
EDISIMU MODE (EDITING AND SIMULATION)
8.
Editing window
·165·
(REF: 1807)
Having the "Hide cycles/profiles" option is active, the editor only shows the name of the
canned cycle or of the profile. Having this option active, when the cursor moves over a hidden
element, it expands automatically; when the cursor moves out of the element, it shrinks
again.
Zoom at the editor.
The editor has the following hotkeys to increase or decrease the size of the editor font. If the
CNC has a mouse with a wheel, the [CTRL] key combined with this wheel can also be used
to increase and decrease the size of the text font.
Multi-line blocks.
[CTRL]+[+] Zoom in.
[CTRL]+[–] Zoom out.
The editor adjusts the long blocks to the size of the window dividing the block
into several lines. On the right side of each cut line, the editor shows a symbol
to indicate that the block continues in the next line.
To Next Page
Loading...
